Maintenance and troubleshooting, Alignment screw, 90° verification – MK Diamond MK-770 EXP User Manual
Page 34
34
Rotate Counterclockwise
to loosen
Lower
Screw
No gaps between
Blade and Square
Alignment Screw, 90° Verification:
NOTES: If the blade is misaligned following this alignment procedure, return the saw to MK Diamond for
repair. The Diamond Blade must be removed and reinstalled when removing the Blade Guard.
90º-alignment verification will ensure that the blade will cut the tile straight up and down and not at an angle.
(B)
Locate the 90°
Adjustment Screw
(A)
Position the Cutting Head
to the 45º Cutting Angle
(C)
Rotate 90° Adjustment Screw
clockwise or counter-clockwise
to realign Cutting Head
(E)
Verify the Diamond Blade
is Square to the Movable
Cutting Table
(D)
Position the Square on
Movable Cutting Table
against the Diamond Blade
(F)
Repeat Steps A to E as
necessary to align the
Cutting Head
MAINTENANCE AND TROUBLESHOOTING