MTS Landmark Floor Standing - Manual (Page 73)

Service
Most normal service requirements can be met utilizing the normal three operating modes as listed previously.
However, there can be circumstances where operation in full flow mode with the test area enclosure open is
required. In these cases, trained service personnel can disconnect the standard enclosure cable, and
temporarily replace it with a service connector. This operation is not considered typical use, and should only
be used by trained individuals.
Emergency Stop and Actuator Velocity Limiting Switch
The emergency stop switch and actuator velocity limiting switch function the same as those on the control
panel.
Enclosure Controls
Description Item
Emergency Stop Switch 1
Actuator Velocity Limiting Switch 2
Interlock logic
The interlock logic is as follows:
MTS Landmark™ Floor Standing Load Units Product Information 73
Operation