MTS Landmark Floor Standing - Manual (Page 77)

Annually Biweekly Weekly Daily Calendar Time using 8 hour Running
Time Rate Per Day
2,000 1,500 1000 500 80 40 8 Running Time-Hours
MTS MTS MTS MTS MTS Ensure that the crosshead columns are
clean.
MTS MTS MTS MTS MTS Ensure that there are no extreme column
abrasions.
MTS MTS MTS MTS MTS Ensure that the crosshead speed is
appropriate.
MTS MTS MTS MTS MTS Test to ensure the crosshead unlock causes
a program interlock.
MTS MTS MTS MTS MTS Check the condition of all load frame support
airbags and pads.
MTS MTS MTS MTS MTS Ensure that the crosshead movement is
smooth.
MTS MTS Ensure that the hydraulic crosshead locks
are functioning properly.
MTS MTS Bleed the crosshead lift cylinders.
MTS Lubricate the manual crosshead lock bolts.
MTS Replace the hydraulic lock cap screws.
6
Actuator
MTS MTS MTS MTS Complete a cursory check of the actuator.
MTS MTS MTS MTS Ensure that the actuator area is dry.
MTS MTS MTS MTS Ensure that the actuator platen area is
clean.
MTS MTS MTS MTS Ensure that the piston rod wear is at an
acceptable level.
MTS MTS MTS MTS Lubricate the axial/torsional spline. (Bionix
frame at 75-100 hrs)
MTS MTS MTS MTS Verify the performance at low velocity in the
up direction.
MTS MTS MTS MTS Verify the performance at low velocity in the
down direction.
6
Replacement of the hydraulic crosshead lock cap screws is recommended every 5 years or 5500 duty cycles,
whichever comes first.
MTS Landmark™ Floor Standing Load Units Product Information 77
Maintenance