MTS Landmark Floor Standing - Manual (Page 39)

Unpack the Load Unit (Horizontal Configuration)
1. Cut the packing straps and remove any bolts as needed. Make sure the lifting eyebolts are tight.
2. Inspect the load unit for shipping damage. Look for the following:
• Scratches in the load unit or lift cylinder columns
• Damaged electrical connections
• Damaged hydraulic connections
• Dents and other structural damage
• Torn, kinked, or breaking hoses
Report any damage found to both the carrier and MTS. In the U.S. and Canada, call the MTS HELPLine
at 1-800-328-2255. Elsewhere, contact your local MTS office.
3. Lift the load unit upright.
a) Attach the lifting hooks to the lifting eyebolts for actuator integral to the base models, or attach slings
around the crosshead for actuator integral to the crosshead models. Move the crane/forklift to keep
the chains as perpendicular to the floor as possible.
b) Slowly raise the load unit to its upright position. As the unit rises, keep moving the crane to keep the
chains as perpendicular to the floor as possible. Do not exceed a 30° chain angle.
c) Use caution when passing the center of gravity.
d) Once the load unit is upright, raise it slightly so that the pallet can be removed.
MTS Landmark™ Floor Standing Load Units Product Information 39
Installation