MTS Landmark Floor Standing - Manual (Page 79)

Annually Biweekly Weekly Daily Calendar Time using 8 hour Running
Time Rate Per Day
2,000 1,500 1000 500 80 40 8 Running Time-Hours
MTS MTS MTS MTS Ensure that the turning parameters are
appropriate and the system is stable.
MTS MTS MTS MTS Ensure that the E-Stop is in working
condition. (If applicable.)
MTS MTS MTS MTS Check the visual and audible response to a
full stroke waveform.
MTS MTS MTS MTS Check the displacement control and valve
balance.
MTS MTS MTS MTS Check the valve dither response.
MTS MTS MTS MTS Verify that the High/Low Velocity Switch light
turns on when the load unit is running on
high.
MTS MTS MTS MTS Verify that low velocity causes a program
interlock.
Grips
MTS MTS MTS MTS Complete a cursory check of the grips and
the grip controls.
MTS MTS MTS MTS Ensure that the grip supply connections are
dry.
MTS MTS MTS MTS Ensure that the grip seals are dry.
MTS MTS MTS MTS Ensure that the grip action is acceptable.
MTS MTS MTS MTS Lubricate the grip inserts.
Other Maintenance Tasks
The following table lists the recommended interval for each of these procedures.
Load Unit Maintenance Intervals
When to Do It What to Do
Before the start of each day’s testing. Make daily inspections.
MTS Landmark™ Floor Standing Load Units Product Information 79
Maintenance