MTS Landmark Floor Standing - Manual (Page 84)

Rust Prevention Recommendations
Description Item
Unpainted surfaces: Spray with silicone, and then wipe with a clean, lint-free cloth.
Or, wipe with a clean, lint-free cloth dampened with clean hydraulic fluid. 1
Chrome plated surfaces: For microscratches, wipe with a clean, lint-free cloth dampened
with ethanol. For rust discoloration, polish with a very fine emery cloth, and then wipe
down. 2
Painted surfaces: For small scratches, use touch-up paint. For large scratches, sand,
prime, and use touch-up paint. 3
Black oxide surfaces: Spray with silicone, and then wipe with a clean, lint-free cloth.
Or, wipe with a clean, lint-free cloth dampened with clean hydraulic fluid. 4
Maintain Airmount Pressures
Optional inflatable airmounts reduce vibration and noise. They are installed under the feet of the load unit.
Inflation pressures must be maintained to both level and isolate the load unit.
Warning:
Airmounts can be overinflated and then explode.
You can be seriously hurt if an airmount explodes, sending fragments flying.
Only inflate airmounts that have the full weight of the load unit resting on them. Never inflate an
airmount above 0.41 MPa (60 psi). Check airmount pressures with an accurate pressure gage.
Each airmount's inflated height—measured from the floor to the bottom of the load unit’s
leg—should be 57–63 mm (2.25–2.5 in).
Warning:
Airmounts can be overinflated and then explode.
You can be seriously hurt if an airmount explodes, sending fragments flying.
Only inflate airmounts that have the full weight of the load unit resting on them. Never inflate an
airmount above 0.55 MPa (80 psi). Check airmount pressures with an accurate pressure gage.
Each airmount's inflated height—measured from the floor to the bottom of the load unit’s
leg—should be 83–89 mm (3.25–3.5 in).
1. Check the inflation pressures on each airmount. Bleed any airmount whose pressure is above 0.41 MPa
(60 psi).
84 MTS Landmark™ Floor Standing Load Units Product Information
Maintenance