MTS Criterion Series 40 - Manual (Page 51)

Using the Emergency Stop Control
If something unusual occurs that requires immediate action, use the Emergency Stop (E-Stop) control to:
• Stop whatever setup operation or test you have in progress, and
• Set the interlock.
While using your system, always keep in mind where the E-Stop control is and what it does. The E-Stop
is a large red button on a yellow background and is located on the LUC (load unit control) module. The
Emergency Stop switch stays activated until you twist the knob as indicated by the arrows.
Understanding the Load Train
The load train imparts force on a specimen so that its material properties can be tested. It is important to
eliminate play from the load train to ensure accurate results.
Scissors grips are shown in this example, although the concepts apply to most other grip configurations.
MTS Criterion ™ Series 40 | 51
Key Concepts