MacDon R85 Rotary Disc 16 Foot Pull-Type - Manual (Page 190)

MAINTENANCE AND SERVICING
9. Rotate driveline 1/4 turn so that clamp bolt (A) in yoke
is accessible.
10. Remove clamp bolt (A) with a 3/4 in. wrench.
Figure 8.72
11. Insert a wedge into the split (A) to loosen yoke.
12. Slide driveline forward until clear of splined pump shaft.
13. Remove wedge (if necessary) and remove driveline
from casting.
Figure 8.73
Installing the Driveline
Follow these steps to install the driveline:
1. Insert driveline into casting.
2. Drive a small wedge into split (B) in yoke.
3. Push yoke onto end of splined pump shaft (A).
4. Remove the wedge and rotate driveline so that opening
in yoke is accessible.
Figure 8.74
169456
180
Rev. D