MacDon R85 Rotary Disc 16 Foot Pull-Type - Manual (Page 203)

MAINTENANCE AND SERVICING
1. Raise mower conditioner to full height, stop engine,
and remove key from ignition.
2. Engage lift cylinder lock-out valves. See Section 5.3
Lift Cylinder Lock-Out Valves, page 30 .
3. Open driveshield. See Section 5.4 Driveshields, page
32 .
Figure 8.100
4. Place a suitable container under drain plug (A).
5. Remove plugs (A) and (B).
6. Allow sufficient time for lubricant to drain.
7. Replace plug (A) and tighten.
Figure 8.101
8. Remove breather and bushing (A) at filler pipe (B).
9. Add 11.8 oz. (350 ml) of Traxon E Synthetic 80W90
gear lubricant to gearbox through filler pipe (B).
NOTE: Lubricant should run out of port (C)
slightly when at the proper level.
10. Reinstall plug (C) and tighten.
11. Reinstall bushing and breather (A) in filler pipe (B)
and tighten.
12. Properly dispose of used lubricant and clean up any
spilled lubricant.
13. Close driveshield.
Figure 8.102
169456
193
Rev. D