MacDon R85 Rotary Disc 16 Foot Pull-Type - Manual (Page 191)

MAINTENANCE AND SERVICING
5. Insert bolt (A) with large washer (B) under head, two
small washers (C), and one thin washer (D) into yoke,
and thread onto pump shaft.
6. Tighten bolt (A) with a 15/16 in. wrench so that driveline
is drawn onto pump shaft.
NOTE: Ensure there is 0.060 in.
(1.5 mm)
minimum clearance (E) between the
yoke and the casting. Add extra washer
if necessary.
7. Torque bolt (A) to 150 lbf·ft (203 N·m).
Figure 8.75
E - minimum clearance 0.060 in. (1.5 mm)
8. Rotate driveline 1/4 turn so that clamp bolt can
be installed.
9. Install clamp bolt (A) and nut with a 3/4 in. wrench and
torque to 55 lbf·ft (75 N·m).
10. Reinstall the drawbar adapter or 3-point hitch adapter.
Figure 8.76
169456
181
Rev. D