RKI Instruments Beacon 110 User Manual
Page 15
Beacon 110 Operator’s Manual
11
NOTE:
See “Chapter 3: Installation & Startup” on page 12 for complete Beacon 110
installation instructions.
CAUTION:
Do not adjust the strobe brightness or the horn volume at the strobe/horn, as this
may overload the Beacon 110 strobe control circuit.
The horn/strobe does not come factory installed to the Beacon 110. To install the horn/
strobe:
1.
Mount the horn/strobe in the desired location.
2.
Install an appropriately rated cable bushing or conduit to the left conduit hub on the
bottom of the Beacon 110 housing.
3.
Install an appropriately rated cable bushing or conduit at the horn/strobe.
4.
Run a cable or wires in conduit from the horn/strobe to the Beacon 110 through the left
conduit hub.
5.
Connect the wires to the strobe terminal strip as shown in the figure below.
Figure 5: Horn/Strobe Wiring/Outline and Mounting Dimensions
+
Dimensions S hown in Inches
-
5.97
6.81
4.83
6.17
Strobe Terminal S trip