RKI Instruments Beacon 110 Rig Monitor - Manual (Page 17)

Beacon 110 Rig Monitor Operator’s Manual 12
1. Select the mounting site. When you select the mounting site consider the following factors:
• Is a DC power source available?
• Is there enough room to open the housing door and make wiring connections through the
cable bushings at the bottom of the housing?
• Are the display screen and status lights on the Rig Monitor visible?
2. If necessary, close and latch the Rig Monitor housing door.
3. Position the monitor on a vertical surface at eye level (4 1/2 to 5 feet from the floor).
4. Insert 1/4 in. or 5/16 in. screws through the slots in the Rig Monitor mounting feet at each
corner of the housing to secure the housing to the mounting surface.
5. Use the mounting bracket to hang the H
2
S detector at approximately breathing level.
Figure 6: Junction Box Outline & Mounting Dimensions
6. At the monitoring site you select, hang the junction box with the detector facing down (see
Figure 6).
To Right
Cable
Bushing
Ø .75
.75
To Left
Cable
Bushing
1.50
Mounting
Bracket
Detector
Cable
14.2" Max
12 VDC
Battery
Cable