RKI Instruments Beacon 110 Rig Monitor - Manual (Page 29)

Beacon 110 Rig Monitor Operator’s Manual 24
4. When you have scrolled through all the adjustable parameters, SAVE IT? YES/NO appears on
the display.
5. To save the adjustments made, press and release the UP/YES button. Config Saved is
indicated on the display for a few seconds and the Rig Monitor returns to normal operation.
If you do not wish to save the adjustments, press and release the DOWN/NO button. The DO
OVER? YES/NO message will display. Press and release the DOWN/NO button. The
ABORT? YES/NO message will display. Press the UP/YES button to return to normal
operation.
ZeroSupp
(2 ppm) The zero suppression feature helps prevent “jumpy” readings near the
fresh air reading.
For example, if the zero suppression setting for the H
2
S detector is 2
ppm, the Rig Monitor will display a reading of 0 ppm for gas readings
from -2 ppm to 2 ppm.
FILTER
(5 secs) The filter feature helps “smooth out” jumpy or noisy signals from the
detector. You can set the filter from 0 seconds to 60 seconds in 5 sec-
onds increments.
The displayed gas reading is the average reading over the previous time
period defined by the filter setting. So if the filter is set to 5 seconds, the
displayed gas reading is the average over the past 5 seconds.
CAL Time
(15 mins) The calibration time-out sets the amount of time after the last button push
while in Calibration Mode that the Rig Monitor will wait before returning to
normal operation. If the calibration time-out is set to 15 mins, then the
Rig Monitor will return to normal operation automatically 15 minutes after
the last button push.
Table 6: Configuration Parameters (Continued)
Parameter
(Factory Set Value)
Description