RKI Instruments Digester Gas Monitor - Manual (Page 25)

Digester Gas Monitor Operator’s Manual Optional Horn/Strobe • 19
Optional Horn/Strobe
This section describes the optional horn/strobe available for the Digester Gas Monitor. It
can be ordered with the Digester Gas Monitor or it can be ordered at a later date and be
field installed. The horn/strobe is wired to the Strobe Terminal Strip as shown in Figure 8
and Figure 9 below.
NOTE: If the Digester Gas Monitor is not ordered with a horn/strobe, the hole that is
intended for use with the horn/strobe will be plugged and the receptacle will not
be installed.
Figure 8: Strobe Terminal Strip Location
The Digester Gas Monitor can be ordered with a horn/strobe. This optional horn/strobe
allows the user to have both a strobe and a horn connected to the “Strobe” terminals of the
Digester Gas Monitor. Strobe operation can be programmed in the Global Menu (see
“Chapter 5: Global Menu” on page 47) and in Configuration Mode (see “Chapter 6:
Strobe Terminal Strip
Strobe Receptacle