RKI Instruments Digester Gas Monitor - Manual (Page 58)

52 • Viewing and Changing Channel Parameters Digester Gas Monitor Operator’s Manual
2. Press and release the UP/YES button to continue in the Configuration Menu to the
Select Channel Screen.
3. Use the UP/YES or DOWN/NO buttons to select the channel whose parameters you
want to view and/or update, then press and release the ENTER button. The first
channel parameter screen appears and it allows you to select whether the channel is
set to ACTIVE, STANDBY, or, NOT USED.
4. Press and release the UP /YES or DOWN/NO button until the setting you want to
select appears, then press and release the ENTER button to save it. The next channel
parameter screen appears.
NOTE: If you selected STANDBY or NOT USED, the display will ask you if you still want
to review the channel settings. If yes, press and release the UP/YES button and
continue with step 5. If no, press and release the DOWN/NO button and proceed
to step 9.
NOTE: Use the ESCAPE button to go backwards in the menu.
5. In the parameter screens, use the ENTER button to accept a displayed parameter
setting and proceed to the next parameter or the ESCAPE button to back up a screen.
6. If you want to change a displayed parameter setting, use the UP/YES or DOWN/NO
button to change the parameter to the desired setting, then press and release the
ENTER button to accept the change and proceed to the next screen. The available
parameters are listed below in Table 8.
7. Continue through the parameter setting screens changing any parameter settings as
needed until the following message appears on the display.
8. To save the channel parameter settings, press and release the UP /YES button.The
screen will indicate that the Digester Gas Monitor is saving the settings for a few
seconds.
If you do not want to save the channel parameter settings, press and release the
Select Channel
1
UP / DN then ENT / ESC
CHANNEL: 1
ACTIVE
UP / DN then ENT / ESC
Save Settings?
[Y / N]
[ESCAPE] to back up