RKI Instruments Digester Gas Monitor - Manual (Page 63)

Digester Gas Monitor Operator’s Manual Overview • 57
Chapter 7: Input Setup Menu
Overview
This chapter describes how to use the Input Setup Menu to select each channel’s detector
input type and the gas setup. The detector input type determines whether a direct connect
type or a 4 - 20 mA type of detector will be used and the gas setup determines the target
gas, detection units, and the detection range full scale. The Input Setup Menu is accessed
using the ENTER control switch when powering up the Digester Gas Monitor.
The Input Setup Menu includes a 5-minute timeout feature. If you do not press a button for
5 minutes, the Digester Gas Monitor automatically returns to Standby Mode.
NOTE: The Digester Gas Monitor will begin its warm-up sequence when it exits the Input
Setup Menu before it enters Standby Mode for both a program timeout or
because you are done with input setup and are exiting manually.
Selecting the Detector Head Input
Type and Gas Setup
NOTE: The Digester Gas Monitor must be turned off before you can enter the Input
Setup Menu. If your Digester Gas Monitor is already installed and operating,
make sure that turning the Digester Gas Monitor off will not cause unwanted
alarms before continuing.
1. While the Digester Gas Monitor is off, press and hold the ENTER button, then turn on
the Digester Gas Monitor with the ON/OFF switch.
2. Continue to press the ENTER button while the Digester Gas Monitor turns on and the
display shows RKI Instruments Beacon 410 Digester Gas Monitor. Release the
ENTER button when the following screen appears on the display.
3. If you want to exit the Input Setup Menu, press and release the DOWN/NO button.
The Digester Gas Monitor will exit the Input Setup Menu and begin the warm-up
sequence.
If you want to continue in the Input Setup Menu, press and release the UP/YES
button. The Select Channel(s) screen will appear.
4. The setup that you perform will apply to all the channels that you select. Select the
channel or channels you want to setup by using the UP/YES or DOWN/NO buttons to
You Have Entered The
INPUT SETUP Menu
Continue? [Y / N]
Select Channel
1
UP / DN then ENT / ESC