Classic-craft panel installation – Therma-Tru SHOP 3 Door Preparation - U1 Revised User Manual
Page 31
Advertising
Door
Preparation
Shop 3
2014 (U1 REVISED)
3.31
Classic-Craft Panel Installation
1. Moisten a clean cloth with 70%
Isopropyl Alcohol. Wipe flat
surface around entire perimeter
of opening. Allow to dry.
Not preparing door will result
in poor panel adhesion.
3. Position panel in opening
and press down firmly
around outside edges.
Note:
DP300CC used on CC30300 only. DP300CCM used on CCM30300. Temperature range for
optimal tape adhesion is 70° to 100°F. Minimum suggested application temperature is 50°F.
2. Remove carrier backing
from tape on back of panels.
Carrier backing
Clean flat
surface all
around
perimeter
with alcohol
Panel
Door
Press here with
approximately 10 psi.
Insulating Foam
Advertising