Therma-Tru SHOP 3 Door Preparation - U1 Revised - Manual (Page 41)

Door
Preparation
Shop 3 2014 (U1 REVISED) 3.41
Hinge Installation
Pass-Through Mortise
Align and Install Hinges
Place tabs firmly against door skin.
Fasten 2-knuckle hinge leaves with proper
screws.
Full Mortise
Align and Install Hinges
Use mortises to properly
align 2-knuckle hinge leaves.
Drill 1/8” diameter pilot
holes if mounting hinges to
hardwood stiles.
Fasten 2-knuckle hinge
leaves with proper screws.
2-Knuckle
Door Leaf
With Tabs
3-Knuckle
Jamb Leaf
#10 x 1”
Phillips flat
Head screw
Part # RPSCDRB-XX
Pilot holes
Required for
hardwood stiles
(Classic-Craft only)
#10 x 1”
Phillips flat
head screw
Use the Correct Leaf
Leaves applied to door have 2 knuckles.
Leaves applied to jamb have 3 knuckles.
Place hinge
tabs firmly
against door.
Part # RPSCDRB-XX