Therma-Tru SHOP 3 Door Preparation - U1 Revised - Manual (Page 48)

Door
Preparation
3.48 2014 (U1 REVISED) Shop 3
Grille Installation
Installation for Flush-Glazed Doors
To assure proper installation, carefully remove any excess sealant at glass
edge before installing grille clips.
Insert steel spring clips between stop and glass at the locations shown.
AVOID PUTTING CLIPS IN LINE WITH MUNTINS HORIZONTAL
AND VERTICAL GRILLE BARS. (Note: number of clips may vary from
shown due to grille size and door style.
Use the installation tool as shown
to push the clip completely into the
locked position.
With all the clips installed, insert grille against clips on one
side. Gently push opposite side of grille against glass,
locking all clips into frame. Remember to gently press the
top and bottom of the grille against the glass.
Clips will be hidden when grille is inserted.
To remove, gently pull away from the glass surface at one
long side of the grille where the muntins meet the grille
frame.
Section Cut for Clarity
Sealant