Therma-Tru SHOP 3 Door Preparation - U1 Revised - Manual (Page 35)

Door
Preparation
Shop 3 2014 (U1 REVISED) 3.35
Doorlite & Designline
Panel Installation
Separate Lite or Panel Frames
Always place door in HORIZONTAL position before removing lite
or panel.
Remove screws or staples to separate
lite or panel frames.
Apply Glazing Tape to Entire Perimeter
of Exterior Frame
If not factory applied, apply foam
glazing tape (Part No. RPGLZTP).
DO NOT stretch.
Overlap at corners.
Press on lightly with fingers. Then with
a roller tool, fully bond gasket using firm
pressure.
Position Lite/Panel into
Opening
Place lites and panels against bottom
edge of cutouts to prevent shifting.
Center lites and panels in cutout,
side-to-side
Interior side
Exterior lite frame
(half with glass)
Exterior panel
.