Therma-Tru SHOP 3 Door Preparation - U1 Revised - Manual (Page 60)

Door
Preparation
3.60 2014 (U1 REVISED) Shop 3
5DLQ'HÀHFWRU,QVWDOODWLRQ
Align
Rain
Deflector
Base
Exterior
Sealant Channel
#8 x 1” stainless steel
phillips pan head screw
Base
Fin
Sealant
Sealant
Exterior
Apply bead of sealant in channel on rain deflector base.
Center rain deflector base on exterior face of panel
and align edge of rain deflector base with bottom
edge of panel.
Attach rain deflector base to panel with #8 x 1”
phillips pan head screws.
Slide rain deflector fin into channel on base.
Apply a 2” long bead of sealant up under the fin
at the center of the door to prevent fin from sliding.
Attach Rain Deflector
Sealant type must be a paintable or stainable elastomeric or polyurethane.
Rain Deflector Cut Down Instructions:
3/0 - No cut down required.
2/10 - Cut 1” off both ends of 3/0 deflector.
2/8 - Cut 2” off both ends of 3/0 deflector.
2/6 - Cut 3” off both ends of 3/0 deflector.
2/4 - Cut 8” off one ends of 3/0 deflector.