Rockwell Automation 20D-P2-DG03 DriveGuard Safe Torque Off Option for PowerFlex 700S Phase II and 700L Drives - Manual (Page 18)

18 Rockwell Automation Publication 20D-UM007G-EN-P - March 2012
Chapter 2 Installation and Wiring
PowerFlex 700S, All Frames, and PowerFlex 700L, Frame 3
2. Remove the screws securing the interior cassette cover to gain access to the
Main board.
3. Remove the 2-pin shunt jumper from the 16-15 pin position.
16
15
IMPORTANT If the DriveGuard Safe Torque Off option is removed from the drive,
this jumper must be reinstalled or the drive will not run.