Rockwell Automation 20P, 23P PowerFlex DC Drive and SAR Control Circuit Board Installation Instructions - Manual (Page 14)

Publication 20P-IN004B-EN-P
14
2. Carefully disconnect the cables from connectors XFCD, XA, and XR on the
control board.
3. Remove the plug-in I/O and control terminal blocks with the wiring kept in
place.
4. Remove the five screws that secure the control board to the control EMI
shield and remove the board from the drive.
=
Disconnect
cables
Disconnect I/O
and control
wiring
Remove screws
Tightening torque:
1.0 N•m (8.9 lb•in)