Rockwell Automation 20P, 23P PowerFlex DC Drive and SAR Control Circuit Board Installation Instructions - Manual (Page 9)

9
Publication 20P-IN004B-EN-P
3. Carefully lift the resolver interface module off of the control board, pulling
the stacker connector out of the XRE connectors on the control board.
Important: Lift the resolver interface board straight up so that the stacker
connector pins do not bend or break.
4. Remove the four stand-offs and washers that support the resolver interface
board on the control board.
Resolver
interface board Control board
XRE connector
Control board
Resolver interface board
Stacker
connector
Capped pins
to right
Bottom view
Side view
XRE
connector