Rockwell Automation 20P, 23P PowerFlex DC Drive and SAR Control Circuit Board Installation Instructions - Manual (Page 16)

Publication 20P-IN004B-EN-P
16
Step 9: Document the
Change 1. Record the installation of the new control board and date of installation on
the field installed option label on the side of the drive (as shown below).
2. Replace the drive covers in the reverse order of removal as described in Step
3: Remove the Drive Covers on page 3 .
3. Install DPI cable (if present).
4. Down load the parameter configuration back into the drive.
Related Documentation Allen-Bradley publications are available on the internet at
www.rockwellautomation.com/literature .
Frame A Shown
For . . . Read this document
Publication
Number
In-depth information regarding the
operation of PowerFlex Digital DC drives User Manual - PowerFlex Digital DC Drives 20P-UM001
In-depth information regarding the
installation and wiring of the resolver
feedback option module Installation Instructions - PowerFlex DC
Drive Resolver Feedback Option Module 20P-IN071
In-depth information regarding the
installation and wiring of the I/O
expansion circuit board PowerFlex DC Drive Analog and Digital
I/O Expansion Circuit Board 20P-IN002
In-depth information regarding the
installation and wiring of the115V AC to
24V DC converter board PowerFlex DC Drive 115V AC to 24V DC
I/O Converter Circuit Board 20P-IN003