Rockwell Automation 20P, 23P PowerFlex DC Drive and SAR Control Circuit Board Installation Instructions - Manual (Page 15)

15
Publication 20P-IN004B-EN-P
Step 7: Install the New
Control Board 1. Install the new control board in the reverse order of removal as detailed in
Step 6: Remove the Existing Control Board on page 13 .
2. Verify that all DIP switch and jumper settings match those recorded in the
chart on page 13 . Refer to the PowerFlex DC Digital Drive User Manual,
publication 20P-UM001 , for detailed information on DIP switch and
jumper settings.
Step 8: Wire the Control
Board Install the I/O and control wiring in reverse order of removal.
Figure 1 I/O and Control Wire Routing
Route I/O and control
wiring between
bottom front cover
and power terminal
cover/shield.
(Frame A shown)