Rockwell Automation 20P, 23P PowerFlex DC Drive and SAR Control Circuit Board Installation Instructions - Manual (Page 7)

7
Publication 20P-IN004B-EN-P
3. Remove the four screws that secure the adapter to the EMI shield and
remove the adapter.
4. Remove the three screws that secure the EMI shield to the stand-offs on the
control board and remove the EMI shield.
5. Remove the three stand-offs from the control board.
Remove four screws
Tightening torque:
0.9 N•m (8 lb•in)
Remove three screws
Tightening torque:
1.0 N•m (8.9 lb•in)
Remove three standoffs
Tightening torque:
1.0 N•m (8.9 lb•in)