Rockwell Automation 20P, 23P PowerFlex DC Drive and SAR Control Circuit Board Installation Instructions - Manual (Page 6)

Publication 20P-IN004B-EN-P
6
Disconnect the HIM Communication Cable
For all drives, disconnect the HIM communication cable from the connector on
the upper right corner of the control board and set the cover aside.
Step 4: Remove the
Communication Adapter
and EMI Shield If a communication adapter is not installed, continue with step 4 on page 7 .
1. Disconnect the interface cable from the adapter and set it aside.
2. Disconnect any network cables from the adapter and set them aside.
Pull tabs out
to disconnect
cable.
=
All Frames
(Frame A shown)
Disconnect interface cable
Disconnect network cables