Rockwell Automation 20P, 23P PowerFlex DC Drive and SAR Control Circuit Board Installation Instructions - Manual (Page 5)

5
Publication 20P-IN004B-EN-P
Frame D Drives
1. Disconnect the DPI cable from the HIM assembly (if present).
2. Loosen, but do not remove, the four hexalobular screws that secure each of
the three covers to the control pan on the drive, then slide the covers up and
off the drive chassis. Tightening torque is noted in the illustration for
reassembly.
Important: A communication cable connects the HIM assembly to the
control board mounted on the control pan. Therefore, the
middle control pan cover and HIM assembly cannot be fully
removed from the drive until the cable is disconnected.
3. Continue with Disconnect the HIM Communication Cable on page 6 .
=
Disconnect
DPI cable
Tightening torque:
1.5 N•m (13 lb•in)
T15
Loosen
screws Loosen
screws