Rockwell Automation 22-COMM-C ControlNet Adapter - Manual (Page 22)

2-4 Installing the Adapter
PowerFlex 40 Frames B and C, and PowerFlex 400 Frame C
1. Remove power from the drive.
2. Use static control precautions.
3. Mount the adapter on the required special drive cover (ordered
separately — see Figure 2.4 for part numbers).
• Frame C: Use the adapter screw to secure the adapter to the cover.
• Frame B: Disregard the screw and snap the adapter in place.
Important: For Frame C drives, tighten the adapter’s lower left
screw to ground the adapter (see Figure 2.4 ). For Frame
B drives, install the special drive cover onto the drive
using both cover fasteners to ground the adapter.
4. Connect the Internal Interface cable to the DSI port on the drive and
then to the mating DSI connector on the adapter.
Figure 2.3 Connecting DSI Ports with Internal Interface Cable
Connecting the Adapter to the Drive
Item Description
➊
DSI connector
➋
15.24 cm (6 in.) Internal Interface cable
➌
ControlNet cable
PowerFlex 40 Drive
(Frame C shown
with cover removed) Back of Required
Special Drive Cover
22-COMM-C Adapter
➋
➊
➌