Rockwell Automation 22-COMM-B PowerFlex BACnet MS/TP Adapter - Manual (Page 25)

Installing the Adapter 2-9
Apply power to the drive. The adapter receives its power from the
connected drive. When you apply power to the adapter for the first time,
its topmost status indicator “PORT” should be solid green after an
initialization. If it is red, there is a problem. Refer to
Chapter 5 ,
Troubleshooting .
Start-Up Status Indications
Status indicators for the drive and communications adapter can be
viewed on the front of the drive (
Figure 2.8 ) after power has been
applied. Possible start-up status indications are shown in Table 2.B .
Figure 2.8 Drive and Adapter Status Indicators (location on drive may vary)
Applying Power
!
ATTENTION: Risk of equipment damage, injury, or death exists.
Unpredictable operation may occur if you fail to verify that parameter
settings and switch settings are compatible with your application.
Verify that settings are compatible with your application before
applying power to the drive.
➋
➊