Rockwell Automation 22-COMM-B PowerFlex BACnet MS/TP Adapter - Manual (Page 46)

5-2 Troubleshooting
PORT Status Indicator
State Cause Corrective Actions
Off The adapter is not powered or
is not properly connected to
the drive.
•
Securely connect the adapter to the drive
using the Internal Interface (ribbon)
cable.
•
Apply power to the drive (or adapter if
mounted in a DSI External Comms Kit).
Flashing
Red The adapter is not receiving
communication from the drive.
•
Verify that cables are securely connected
and not damaged. Replace cables if
necessary.
• Cycle power to the drive (or adapter if
mounted in a DSI External Comms Kit).
Orange The adapter is connected to a
drive that is not compatible. Connect the adapter to a compatible
PowerFlex 4, PowerFlex 4M, PowerFlex 40
or PowerFlex 400 drive.
Flashing
Green The adapter is establishing
communications with the
drive. No action required. This status indicator will
turn steady green or flashing red.
Steady
Green The adapter is properly
connected and is
communicating with the drive. No action required.
MOD Status Indicator
State Cause Corrective Actions
Off The adapter is not powered or
is not properly connected to
the drive.
•
Securely connect the adapter to the drive
using the Internal Interface (ribbon)
cable.
• Apply power to the drive (or adapter if
mounted in a DSI External Comms Kit).
Flashing
Red The adapter has failed the
firmware test. • Cycle power to the drive (or adapter if
mounted in a DSI External Comms Kit).
•
If cycling power does not correct the
problem, the adapter parameter settings
may have been corrupted. Reset defaults
and reconfigure the adapter.
•
If resetting defaults does not correct the
problem, flash the adapter with the latest
firmware release.
Flashing
Green The adapter is operational, but
is not transferring I/O data. Enable the network device that is providing
control to the adapter.
Steady
Green The adapter is operational and
transferring I/O data. No action required.