Rockwell Automation 20-COMM-S RS-485 DF1 Adapter - Manual (Page 13)

Getting Started 1-5
This section is designed to help experienced users configure or set up the
RS-485 DF1 adapter. If you are unsure how to complete a step, refer to
the referenced chapter.
Quick Start
Step Refer to
1 Review the safety precautions for the adapter. Throughout This
Manual
2 Verify that the PowerFlex drive is properly installed. Drive User
Manual
3 Commission the adapter.
Set a unique node address and the appropriate data rate using
the switches on the adapter. If desired, you can disable the
switches and use parameter settings instead.
Chapter 2 ,
Installing the
Adapter
4 Install the adapter.
Verify that the PowerFlex drive is not powered. Then, connect the
adapter to the network using a RS-485 cable and to the drive
using the Internal Interface cable. Use the captive screws to
secure and ground the adapter to the drive.
Chapter 2 ,
Installing the
Adapter
5 Apply power to the adapter.
The adapter receives power from the drive and network. Apply
power to the network and to the drive. The status indicators
should be green. If there is a problem, refer to
Chapter 4 , Using
DriveExplorer on the RS-485 Network .
Chapter 2 ,
Installing the
Adapter
6 Configure the adapter for your application.
Set the parameters for the following features as required by your
application:
• I/O configuration.
• Fault actions.
Chapter 3 ,
Configuring the
Adapter
7 Apply power to the RS-485 DF1 master.
Verify that the master and network are installed and functioning in
accordance with RS-485 DF1 standards.