Mod status indicator, Net a status indicator, Mod status indicator -3 net a status indicator -3 – Rockwell Automation 20-COMM-S RS-485 DF1 Adapter User Manual

Page 35

Advertising
background image

Troubleshooting

5-3

MOD Status Indicator

Status

Cause

Corrective Action

Off

The adapter is not
powered.

• Securely connect the adapter to the drive

using the ribbon cable.

• Apply power to the drive.

Flashing
Red

The adapter has failed the
firmware test.

• Clear faults in the adapter.

• Cycle power to the drive.

• If cycling power does not correct the

problem, the parameter settings may
have been corrupted. Reset defaults and
reconfigure the module.

• If resetting defaults does not correct the

problem, flash the adapter with the latest
firmware release.

Solid
Red

The adapter has failed the
hardware test.

• Cycle power to the drive.

• Replace the adapter.

Flashing
Green

The adapter is operational,
but is not transferring I/O
data.

• Place the scanner in RUN mode.

• Program the controller to recognize and

transmit I/O to the adapter.

• Configure the adapter for the program in

the controller.

• Normal behavior if no DPI I/O is enabled.

Solid
Green

The adapter is operational
and transferring I/O data.

• No action.

Net A Status Indicator

Status

Cause

Corrective Actions

Off

The adapter is not powered
or adapter is not connected
properly to the network.

• Securely connect the adapter to the drive

using the Internal Interface cable.

• Correctly connect the RS-485 cable to the

DF1 plug.

• Apply power to the drive.

Flashing
Green

The adapter is properly
connected, but is not
communicating with any
devices on the network.

• Place the controller in RUN mode, or apply

power to the peer device that will send I/O.

• Program a controller or peer device to

recognize and transmit I/O to the adapter.

• Configure the adapter for the program in the

controller or the I/O from the peer device.

Solid
Green

The adapter is properly
connected and
communicating on the
network.

• No action required.

Flashing
Red

A network connection has
timed out.

• Place the scanner in RUN mode, or apply

power to the peer device that will send I/O.

• Check the amount of traffic on the network.

Advertising