Rockwell Automation 20-COMM-S RS-485 DF1 Adapter - Manual (Page 27)

Configuring the Adapter 3-7
Changes to switch settings on some adapter parameters require that you
reset the adapter before the new settings take effect. You can reset the
adapter by cycling power to the drive or by using the following
parameter:
• Set the Parameter 09 - [Reset Module] to Reset Module:
Figure 3.6 Reset Screen on an LCD HIM
When you enter 1 = Reset Module, the adapter will be immediately
reset. When you enter 2 = Set Defaults, the adapter will set all adapter
parameters to their factory-default settings. A reset is still required for
some parameter changes to take effect. The value of this parameter will
be restored to 0 = Ready after the adapter is reset.
Resetting the Adapter
!
ATTENTION: Risk of injury or equipment damage exists. If the
adapter is transmitting control I/O to the drive, the drive may fault when
you reset the adapter. Determine how your drive will respond before
resetting a connected adapter.
Value Description
0 Ready (Default)
1 Reset Module
2 Set Defaults
Port 5 Device
20-COMM-S
Parameter #: 9
Reset Module
1
Reset Module