Rockwell Automation 160 RSI SERIAL COMM MODULE - Manual (Page 11)

Chapter
3
Installation and Wiring
This chapter contains information needed to:
• Meet the requirements of the EMC and Low Voltage directives
for CE compliance.
• Remove a pre-installed Program Keypad Module or Ready/Fault
Indicating Panel.
• Configure and install the RS1 Module.
• Wire the communication cables.
• Remove the RS1 Module from the drive.
Read this chapter completely before you attempt to install or
configure your module. Before applying power, review the Attention
statements presented throughout this manual. Verify that all
connections are secure and that all selections are correct.
EMC Directive 89/336/EEC
Compliance This product complies with Electromagnetic Compatibility (EMC)
Directive 89/336/EEC when conforming with the following
installation requirements:
• The essential requirements for a conforming EMC installation for
the Bulletin 160 SSC are employed. Refer to the Bulletin 160 SSC
User Manual.
Low Voltage Directive 73/23/
EEC Compliance This product complies with Low Voltage Directive 73/23/EEC when
conforming with the following installation requirements:
• The essential requirements for a conforming Low Voltage
Directive installation for the Bulletin 160 SSC are employed.
Refer to the Bulletin 160 SSC User Manual.
• Review the Attention statements in the Preface, and other areas
throughout this manual prior to installation of the module.
!
ATTENTION: Unpredictable operation may occur if you
fail to check connections and DIP switch settings for com-
patibility with your application. Unpredictable operation
may result in personal injury, death, and equipment damage.