Configuration dip switches – Rockwell Automation 160 RSI SERIAL COMM MODULE User Manual
Page 8
Advertising
1–2
Product Overview
Configuration DIP Switches
The Communication Module has one four position DIP switch for
setting the baud rate, protocol and checksum type. DIP switches are
located on the rear of the module (see below) and are only accessible
when the module is removed from the 160 Drive. Refer to Chapter 3
for switch configuration information.
Figure 1.2
Module Rear View
1 2 3 4
ON
SW1 - SW4
DIP Switches
Expansion/Keypad Port
Connector
D-Shell Connector
Module Latch
Advertising