Rockwell Automation 825P Modular Protection System Quick Start Guide - Manual (Page 4)

Quick Start Guide — Allen-Bradley Bulletin 825-P Modular Protection System
4
Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC Low Voltage as
amended by 93/68/EEC by applying the safety requirements of EN 60947-4-1 and
EN 60947-5-1. For specific information required by EN 60947-4-1 and EN 60947-5-
1, see the appropriate sections in this publication.
To obtain a copy of the 825-P’s Declaration of Conformity (DoC), contact your local
Allen-Bradley distributor or go to http://www.ab.com.certification/#CEmark.
Introduction Follow these steps to successfully commission the 825-P Modular Protection System.
Table A: Commissioning Procedure
Step Description
1 General Precautions
2 Hardware Installation
3 Wiring Installation
4 Front Panel Operation
5 System Configuration
6 Port 4 Settings
7 Programming General Parameters
8 Programming Operational Parameters
9 Programming Protection Functions
10 Output Relay and Input Assignments