Rockwell Automation 445L Installation and Operating Instructions - Manual (Page 6)

R
Muting Controller Box Installation and Operating Instructions
6
Original instructions
Four Sensor Muting with GuardShield Micro 400
Figure 3: Wiring four sensor muting (T-Type) with GuardShield Micro 400
If connecting the Micro 400 to the muting
box, the configuration of the MSR42 has to
be changed according to the Software and
Optical Interface section on page 14.
It is necessary to use the original shielded
Micro 400 patchcords (445L-AC8PCX (X is 1,
2, 3, 5, or 8 m)) to connect the Micro 400
transmitter and receiver to the muting
controller.
Not using these cables may cause a safety
risk.
ATTENTION
ATTENTION