Rockwell Automation 1413-CAP-ME-PE Capacitor Bank Controller, Series C - Manual (Page 21)

Rockwell Automation Publication 1413-UM001D-EN-P - November 2010 21
Installation Chapter 2
These views show the panel clamps fully extended to secure the terminal
against the rear of the panel.
5. Insert a mounting lever into each mounting slot on the terminal, sliding
each lever until the short, flat side of the lever touches the surface of the
panel.
6. When both levers are in place, slide each lever an additional notch or two
until you hear a click.
7. Rotate each lever in the direction indicated until it is in the final latch
position.
ATTENTION: Follow the instructions to provide a proper seal and to
prevent potential damage to the terminal. Allen-Bradley assumes no
responsibility for water or chemical damage to the terminal or other
equipment within the enclosure because of improper installation.
6
1
6 1
Fully extended panel clamps
6 1
6 1
Mounting Slot
Short, Flat Side of Mounting Lever
6
Rotate until the short, flat side of the lever
aligns with an alignment mark on the
terminal.
Six Alignment Marks