Rockwell Automation 1413-CAP-ME-PE Capacitor Bank Controller, Series C User Manual
Page 22
22
Rockwell Automation Publication 1413-UM001D-EN-P - November 2010
Chapter 2 Installation
Use this table as a guide to provide an adequate gasket seal between the
terminal and the panel.
Remove the PanelView Component C600 Terminal from the Panel
Follow these steps to remove the terminal from the panel.
1.
Disconnect power to the terminal.
2.
Release the mounting lever by rotating it in the direction indicated, slide it
to the bottom of the mounting slot, and remove it.
3.
Push each panel clamp in until it is fully depressed and locked.
Depressed and locked, the panel clamps provide adequate clearance to
remove the terminal.
4.
Grip the sides of the bezel and gently pull the terminal out of the panel
opening.
Terminal Markings for
Alignment
Lever
Position
Panel Thickness Range
Typical
Gauge
1
1.52…2.01 mm (0.060…0.079 in.)
16
2
2.03…2.64 mm (0.08…0.104 in.)
14
3
2.67…3.15 mm (0.105…0.124 in.)
12
4
3.17…3.66 mm (0.125…0.144 in.)
10
5
3.68…4.16 mm (0.145…0.164 in.)
8/9
6
4.19…4.75 mm (0.165…0.187 in.)
7
6
1
6
6
1
6
1