Rockwell Automation 1500 Modular Protection System Conversion Kit (GE Multilin to Bulletin 825 Plus) - Manual (Page 19)

1500-IN059C-EN-E – June 2013
Installation 4-5
85 Plus Installation
1. Align the 825 Plus interface panel at the rear of the LV door with the
existing mounting holes and cutout.
2. With the self tapping screws provided, mount the front cover and
fasten the interface panel to the rear of LV door, which is located
between the cutout cover and the interface panel.
(Figures 4.10 and 4.11)
3. Ensure an extra long self-tapping screw is used in the top left, as
viewed from the front of mounting hole. (Figure 4.11)
4. Mount the 825 Plus through the low voltage door cutout.
(Figure 4.12)
5. Fasten the 825 Plus to the low voltage door using the four mounting
screws provided with the 825 Plus. (Figure 4.13)
Tighten the screws with minimal force. Do not over
tighten.
Self-tapping hardware is provided. However, pre-tapping
the mounting plates will facilitate easier installation.
Figure 4.10
Figure 4.11
Figure 4.1
Figure 4.1
Figure 4.14
IMPORTANT
IMPORTANT