Rockwell Automation 1500 Modular Protection System Conversion Kit (GE Multilin to Bulletin 825 Plus) - Manual (Page 25)

1500-IN059C-EN-E – June 2013
Installation 4-11
8. Test the control circuit functionality by electrically operating the con-
tactor (air or vacuum) in test mode. This may require the use of test
jumpers depending on the control circuit. Refer to original drawings
supplied with the equipment. (Figure 4.31)
9. Program the 825 Plus with the correct motor and protection parameters.
(Figure 4.32) Refer to Publication 825-UM004B-EN-P, included
with the 825 Plus, for programming instructions.
10. Turn test switch to OFF. Return the controller to service by removing
any test voltage supply and turning the selector switch back to the
"NORMAL" position.
11. Close the low voltage door and tighten down the door screws.
BEFORE:
AFTER:
Figure 
Figure 4.0
Figure 4.1 Figure 4.
Figure 4. Figure 4.4