Rockwell Automation 937CU-AITXF-DC1 Transmitter Supply Converter Installation Instructions - Manual (Page 9)

7
Bul. 937C Transmitter Supply Converter Installation Instructions
1 2 3 4 5 6
PWR
ERR
1 2
OUT
ESC
RS232
OK
7 8 9 10 11 12
13 14 15 16 17 18
19 20 21 22 23 24
Front
The following indicating and operating elements are located on the front of the
Transmitter Supply Converter:
• LED CHK (red) to indicate a device fault
• LED PWR (green) to indicate the presence of the supply voltage
• LED OUT 1 (yellow) to indicate that relay 1 is active
• LED OUT 2 (yellow) to indicate that relay 2 is active
• RS 232 serial interface for a connection to a PC for setting parameters
and diagnosis of the transmitter supply converter using FDT.
• Display for indication of the measured values, fault messages and
parameterization modi
• Four keys for setting the parameters of the transmitter supply converter:
 (Up)  (Down) ESC (Escape) OK