Making field wiring connections, Mount the module to a din rail, Grounding the module – Rockwell Automation 1769-IF16V Compact High Density Analog Voltage Input Module User Manual
Page 11
Compact High-density Analog Voltage Input Module 11
Publication 1769-IN086A-EN-P - August 2008
Mount the Module to a DIN Rail
The module can be mounted using these DIN rails:
•
35 x 7.5 mm (EN 50 022 - 35 x 7.5)
•
35 x 15 mm (EN 50 022 - 35 x 15)
To mount the module on a DIN rail, follow these steps.
1. Close the DIN rail latches.
2. Press the DIN rail mounting area of the module against the DIN rail.
The latches will momentarily open and lock into place.
Making Field Wiring Connections
Use the information in this section includes to wire the module.
•
Grounding the module
•
System wiring guidelines
•
Input sensors/transmitters wiring
•
Terminal labels
•
Finger-safe terminal block wiring and removal
•
Wire size and terminal screw torque
Grounding the Module
This product is intended to be mounted to a well-grounded mounting surface such
as a metal panel. Additional grounding connections from the module’s mounting
tabs or DIN rail, if used, are not required unless the mounting surface cannot be
grounded. Refer to Industrial Automation Wiring and Grounding Guidelines,
publicati
for additional information.