Rockwell Automation 1769-IF16V Compact High Density Analog Voltage Input Module - Manual (Page 7)

Compact High-density Analog Voltage Input Module 7
Publication 1769-IN086A-EN-P - August 2008
Assemble the 1769 System
The following procedure shows you how to assemble the Compact I/O system.
1. Disconnect power.
2. Check that the bus lever of the module to be installed is in the unlocked
(fully right) position.
3. Use the upper and lower tongue-and-groove slots (1) to secure the modules
together or to a controller.
4. Move the module back along the tongue-and-groove slots until the bus
connectors (2) line up with each other.
5. Push the bus lever back slightly to clear the positioning tab (3).
Use your fingers or a small screwdriver.
6. To allow communication between the controller and module, move the bus
lever fully to the left (4) until it clicks, making sure it is locked firmly in
place.
7. Attach an end-cap terminator (5) to the last module in the system by using
the tongue-and-groove slots as before.
ATTENTION
When attaching I/O modules, it is very important that the bus connectors
are securely locked together to be sure of proper electrical connection.
Securely locking together the bus connectors is required for use in
hazardous locations.
For more information on hazardous locations see
page 4 .
1
1 2
3
4
5