Rockwell Automation 1756-CN2RXT ControlLogix-XT ControlNet Interface Module, Series B Installation Instructions - Manual (Page 19)

ControlLogix-XT ControlNet Interface Module 19
Publication 1756-IN634A-EN-P - April 2009
Remove the Module
To remove the module, perform this procedure.
1. Push on the upper and lower tabs to disengage them.
2. Slide the module out of the chassis.
IMPORTANT
If you are removing and replacing an existing module with an
identical one, and you want to resume identical system operation,
you must install the new module with the same ControlNet address
in the same slot.
X
T X
T