Changing the module's configuration – Rockwell Automation 1771-IFE , D17716.5.90 USER MNL. ANALOG INPUT Module User Manual

Page 21

Advertising
background image

Installing the Input Module

Chapter 2

2-9

The analog input module (1771-IFE) has configuration plugs for
determining the input type (voltage or current) desired for each input. The
module comes from the factory with the plugs positioned for
voltage inputs.

To set the configuration plugs for your desired inputs, proceed as follows:

1.

Remove the module’s covers by removing the four screws securing
the covers to the module.

2.

Locate the selection plugs (Figure 2.7).

Figure 2.7

Configuration Plug Locations

Selection Plugs

(refer to Figures 2.8, 2.9 and 2.10)

10950ĆI

3.

Position the plugs as shown in the Figures for your particular module
(Figures 2.8, 2.9 and 2.10).

4.

Reassemble the module after you have finished checking and/or
setting the selection plugs.

Changing the Module's

Configuration

Advertising