Rockwell Automation 1771ACN/B_1771ACNR/B,D17716.5.123 U.MNL CONTROLNET ADAPTER - Manual (Page 15)

Chapter
2
Publication 1771-6.5.123 – May 1996
Installing Your ControlNet
Adapter Module
This chapter describes the procedures for installing your ControlNet
adapter module. These include:
•
CE compliance
•
determining power requirements
•
determining the module location and keying the I/O chassis
•
setting the network address switches
•
setting the I/O chassis switches
•
setting the I/O chassis power supply configuration plug
•
installing the adapter module in the chassis
•
connecting programming terminals to the network via the
network access port (NAP)
•
powerup sequence
If this product has the CE mark it is approved for installation within
the European Union and EEA regions. It has been designed and
tested to meet the following directives.
EMC Directive
This product is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards,
in whole or in part, documented in a technical construction file:
•
EN 50081-2EMC – Generic Emission Standard, Part 2 –
Industrial Environment
•
EN 50082-2EMC – Generic Immunity Standard, Part 2 –
Industrial Environment
This product is intended for use in an industrial environment.
Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC Low
Voltage, by applying the safety requirements of EN 61131–2
Programmable Controllers, Part 2 – Equipment Requirements and
Tests.
Chapter Objectives
Compliance to European
Union Directives