Setting the network address switches – Rockwell Automation 1771ACN/B_1771ACNR/B,D17716.5.123 U.MNL CONTROLNET ADAPTER User Manual
Page 18
Advertising
Installing Your ControlNet Adapter Module
2–4
Publication 1771-6.5.123 – May 1996
The switches on the top of the adapter module determine the network
address of the adapter. The two switches are:
•
the ten’s switch
•
the one’s switch
The combination of these switches allows selection of network
addresses from 01 to 99.
Use a small bladed screwdriver to rotate the switches.
Figure 2.2
Setting the Network Address
Ten’s Selection
One’s Selection
Ten’s Selection
One’s Selection
NET ADDRESS
10
5 = 15
plus
For example, the 10’s selection switch is set to 10,
and the 1’s selection switch is set to 5.
NOTE: 00 is an invalid number.
Then,
Setting the Network
Address Switches
Advertising